1. Tableau Business Intelligence

[Windows Server]See what process is using a TCP/UDP port in Windows Server 2008

Discussion in 'Công nghệ' started by phamthanhnhan14, Jul 2, 2014.

  1. phamthanhnhan14

    phamthanhnhan14 Active Member

    Try to using netstat for WS 2008 :D
    Displays active TCP connections, ports on which the computer is listening, Ethernet statistics, the IP routing table, IPv4 statistics (for the IP, ICMP, TCP, and UDP protocols), and IPv6 statistics (for the IPv6, ICMPv6, TCP over IPv6, and UDP over IPv6 protocols). Used without parameters, netstat displays active TCP connections.
    Syntax
    netstat [-a] [-e] [-n] [-o] [-p Protocol] [-r] [-s] [Interval]
    Parameters
    -a : Displays all active TCP connections and the TCP and UDP ports on which the computer is listening.
    -e : Displays Ethernet statistics, such as the number of bytes and packets sent and received. This parameter can be combined with -s.
    -n : Displays active TCP connections, however, addresses and port numbers are expressed numerically and no attempt is made to determine names.
    -o : Displays active TCP connections and includes the process ID (PID) for each connection. You can find the application based on the PID on the Processes tab in Windows Task Manager. This parameter can be combined with -a, -n, and -p.
    -p Protocol : Shows connections for the protocol specified by Protocol. In this case, the Protocol can be tcp, udp, tcpv6, or udpv6. If this parameter is used with -s to display statistics by protocol, Protocol can be tcp, udp, icmp, ip, tcpv6, udpv6, icmpv6, or ipv6.
    -s : Displays statistics by protocol. By default, statistics are shown for the TCP, UDP, ICMP, and IP protocols. If the IPv6 protocol for Windows XP is installed, statistics are shown for the TCP over IPv6, UDP over IPv6, ICMPv6, and IPv6 protocols. The -p parameter can be used to specify a set of protocols.
    -r : Displays the contents of the IP routing table. This is equivalent to the route print command.
    Interval : Redisplays the selected information every Interval seconds. Press CTRL+C to stop the redisplay. If this parameter is omitted, netstat prints the selected information only once.
    /? : Displays help at the command prompt.
    Enjoy!!!!
    [​IMG]
    with -b option:
    [​IMG]
    using findstr ( same grep in Linux) to specific process:
    [​IMG]
    using tasklisk to view more
    [​IMG]
    kill it if you want:
    [​IMG]

    ^^ That's all.
    NhanPT
     
  2. Loading...

    Similar Threads Forum Date
    [WindowsServer] Active Windows Server 2003 Công nghệ Jul 2, 2014

Share This Page